Settings
2 minutes 10 seconds, in 6 chapters. Recorded in the Engineering Suite itself, with nothing drawn over it but the pointer. There is no sound: each step is captioned, and listed below.

Open 3D partsTo do the same, open 3D parts. It opens on the same mounting plate, so every step in the film can be repeated on it.

The steps

Press a step to play the film from there.

Look round the part

  1. 0:00 3D parts opens on an example, a mounting plate. Drag to turn it, and scroll to zoom.
  2. 0:07 The cube in the corner turns the view a quarter at a time. Top, Front and Right look straight on, and Iso comes home.

Change its size

  1. 0:17 A part is its History: each feature, in the order it was made.
  2. 0:23 Variables hold the sizes the features share. Change the width, and the whole part is built again.
  3. 0:31 Choose a feature to change its own dimensions, on the right. Here, the height of the boss.

Sketch a feature of your own

  1. 0:38 Sketch draws a profile. Choose it, then the plane or the face to draw on.
  2. 0:45 Draw a circle: click its centre, then a point on its edge.
  3. 0:50 Dimension it: with the circle chosen, press D and type its size.
  4. 0:56 Finish the sketch. Extrude then gives it depth: here, a pin standing on the plate.
  5. 1:03 Set how far it goes, and join it to the plate so the two are one body.

Add a feature

  1. 1:10 Fillet rounds edges. Choose it, pick the edges in the view, and press Enter.

Check the part

  1. 1:18 Measure: click an edge or a face for its length, its radius or its area.
  2. 1:25 Section view cuts the part open, to see inside it. Drag the slider to move the cut.
  3. 1:35 Inspect also works out stress, natural frequencies, cost and print time, all on this device.

Send it to be made

  1. 1:42 Export writes STL and 3MF for printing, and STEP with its true surfaces for other CAD.
  2. 1:49 File, Make drawing, lays its views out on a sheet with the model’s dimensions.
  3. 1:58 The drawing opens in Foundry, the suite’s 2D drawing board, to add to, dimension and print to scale.
  4. 2:06 Pick a tool or type a command, as in any drafting program: L, Enter, then click each end of a line.

More

What each part of the Engineering Suite does is written out in Help. The other five tutorials: