Settings

The vehicle

Distances are from the front axle, positive towards the back. A rear bogie counts as one group at its centre, which is how plating works and the only arrangement that can be solved without guessing at the suspension.

What is on it

What it isKilogramsMetres from front

Where the weight sits

Where the next one may go

Item by item

The working


  
How it works

AXLE works out how the weight of the vehicle and its load is shared between the axles from where the load sits, checks each axle against its plated limit and the steering axle against its minimum, and shows where the load can safely go. Your figures stay in this tab.

Questions people ask about AXLE

Why can a vehicle be under its gross weight and still be overloaded?

Because gross weight and axle weights are separate limits and the load decides how the weight divides between them. Put everything behind the middle and the rear axle goes over while the gross is still two tonnes short. A roadside check weighs the axles, so the axle is what gets the prohibition.

How is the share worked out?

By moments about the front axle. Each item has a weight and a distance, the moments are added, and the rear axle takes the total moment less the weight times the front position, divided by the wheelbase. The front takes the rest. It is a line of algebra that decides whether a vehicle is legal, and it is almost never done.

Why does the steering axle have a minimum?

Because steering and braking need weight on the front wheels. Loading heavily behind the rear axle lifts it off, and the driver finds out in the wet. Most codes set a minimum share, and the page reports the actual share against whatever minimum you set.

What is the range of positions for?

It is the question a loader is actually asking: given one more pallet of this weight, where may it go? Both axle limits and the steering minimum are straight lines in the position, so the answer is a window in metres from the headboard. Forward of it the front axle goes over; behind it, the rear does.

Is this a weighbridge?

No, and the page says so. It is the arithmetic, done correctly, from figures you provide. The plated limits are whatever is on your plate and the defaults are ordinary ones meant to be replaced.

Doing this often? The OBSCURA Engineering Suite models parts and assemblies and reports their mass and centre of mass. On its own, US$2 a month; with everything else, US$5 a month or US$48 a year.